FLOW NOZZLE LONG RADIUS TYPE

Definitive advantages result from the use of flow nozzles. For a given ratio of throat pipe to diameter, flow nozzles permits approximately 60% greater capacity than an orifice plate. TM manufacture all type of low nozzle according to ASME, ISA, UNI, DIN, B.S. and all standards.

Technical specifications

Contruction
From forged piece.
The nozzle is a curved convergent entry leading a short cylindrical throat without a discharge cone.

TYPES
High Beta Type
Inlet pressure taps located in the pipe wall at "D" preceding the plae of the nozzle elliptical inlet section, outlet pressure taps located in the pipe wall at "1/2 D" following the plane of the beginning of the elliptical inlet section of the nozzle.

Low Beta Type with or without throat taps
Inlet pressure taps located in the pipe wall at "D" preceding the plane of the nozzle elliptical inlet section, outlet pressure taps located in the pipe or on the nozzle at "1.5 d" following the entrance plane of the nozzle.

STANDARD EXECUTION

Flanged Type
Manufactured in all sizes.
Can be supplied complete with companion flanges.
Welding -in Type with holding-ring
For sizes from 4" and up. Can be supplied completely assembled in a proper honed flow-section. Metering flow-section is of the same material of the line and reamed over the whole lenght after the pressure taps have been fitted. The ends of flow-section can be flanged or beveled as required. Holding ring material: same to the flow-section material
Options Upone request flow nozzles can be supplied complete with: seal pots, stop valves, flow straightening vanes, experimental calibration test to an international approved laboratory.

FLOW NOZZLE ISA 1932

Manufactured according to ISA 1932

Technical specifications

Construction
From forged piece. The nozzle is a curve shaped convergent entry leading to a short cylindrical throat without a discharge cone.

STANDARD EXECUTION

Flanged Type with piezometer rings
Manufactured in all sizes. Supplied in two executions: with separate or integral piezometric rings. Can be supplied complete with companion flanges. Recomended for pipe size up to 16".
Flanged type with corner taps
Manufactured in all sizes.
Can be supplied complete with companion flanges with corner taps.